![]() |
|
|
Operating
Instructions for "Fred"
|
|
|
1
|
Obtain keys from blue back pack located in back office of Clubhouse |
|
2
|
Enter "Fred" from
front deck by unzipping plastic screen then open door from bolt latch
inside. |
|
3
|
Unlock fuel tank
under rear seat, check fuel level and pressurise fuel line bowl, unlock radio compartment, unlock chairs under starboard bench, unlock cupboard under console. |
|
4
|
Turn ON power isolation switch on Battery terminal |
|
5
|
Ensure Radio & Horn switches on console are ON (Test horn, switch on wall on Port side wall) |
|
6
|
Ensure water is deep enough to Trim motor down until water intake is under the water before starting motor |
|
7
|
Start motor by turning key (do not use choke lever, all motors have auto choke) |
|
8
|
Allow motor to warm for 30 seconds |
|
9
|
Ensure mooring chain has been disconnected and is clear of propellor before proceeding carefully between other moorings/boats to deep water. |
|
10
|
Proceed to suitable location and await for instructions as to where to anchor for start line. |
|
11
|
Do radio check with Base and Kabi |
|
12
|
Be wary of fingers in anchor chain latch when anchoring |
|
Preparing for Start |
|
|
|
|
|
|
Returning to Mooring |
|
|
1
|
Proceed carefully back to mooring area. Always approach from easterly direction. (be wary of rocks near eastern end of island and close to point) |
|
2
|
Remember to raise motor before enterring shallow water. |
|
3
|
Ensure mooring chain is correctly attached (back up rope tail should be secured to cleat on bow sprit) |
|
4
|
Raise motor fully and turn
off power. |
|
5
|
Replace keys in back pack and return to Clubhouse |